Attribute 4 of 4, vlanRef (moRef:ManagedObject):
*Enter mo LDN: vlanRef=900
I receive the following error:
!!!! Processing failure :se.ericsson.cello.moframework.WrongAttributeTypeE xception* TAG :"WrongAttributeType" VARIABLES :"$moTypeName" = "Vlan", "$attrName" = "vlanRef"
ERICSSON COMMANDS
1. To check the critical alarms:
allip:acl=a1;For site downs and critical alarms
allip:acl=a2;For major alarms
allip:acl=a3;For minor alarms
2. To check BCCH Frequency:
rldep:cell= cellname;
3. To get the list of all the sites in the BSC:
rldep:cell=all;
4. To check the frequency of a site:
rlcfp:cell=cellname;
5. To check if hopping is enabled or not:
rlchp:cell=cellname;
6.To check if GPRS is enabled or not:
rlgsp:cell=cellname;
7.To check the traffic:
rxtcp:moty=rxotg,cell=cellname;(get TG value)
rxmsp:mo=rxocf-TG No,subord;
8.Signalling and status of channel configuration:
rlcrp:cell=cellname;
9. To lock the site
rxbli:mo=rxocf-TG /CF No.,subord,force;
To unlock the site
rxble:mo=rxocf-TG /CF No.,subord;
10. To lock the TRX
rxbli:mo=rxotrx-TG /CF No.-trx.No.,subord,force;
To unlock the TRX
rxble:mo=rxotrx-TG /CF No.-trx.No.,subord;
11. To lock the time slot:
rxbli:mo=rxotrx-TG /CF No.-trx.No-Ts No,subord,force;
To unlock the time slot
rxble:mo=rxotrx-TG /CF No.-trx.No-Ts No,subord;
12. To find the Dip (ET) Status:
rxtcp:moty=rxotg,cell=cellname;(Get the TG value)
rxapp:mo=rxotg-TG No.(Get the RBLT value)
radep:dev=rblt-RBLT No;(Get the SNT value)
ntcop:snt=etrblt-SNT No;(Get the DIP No)
dtstp:dip=DIP No.;
13. To check configuration of the site:
rxmop:mo=rxotr-CF No-0&&-TRX No.;
14. To find the BTS internal alarms:
rxmfp:mo=rxocf-CF No;
rxmfp:mo=rxotrx-CF No-TRX No;
15. To refresh BTS through software:
rxese:mo=rxocf-CF No,subord;
Bookmarks