Results 1 to 3 of 3

Thread: Ericsson LTE Commands - Advanced

  1. #1
    Level 1 Users
    Join Date
    Dec 2016
    Posts
    3
    Post Thanks / Like
    Credits
    18
    Rep Power
    0

    Ericsson LTE Commands - Advanced

    Ericsson LTE Commands - Advanced
    Created cv
    changes and print the parameters at level of eNodeB

    Similar Threads:

    Attached Files Attached Files

  2. UMTS Interview Questions with Answers(150 Questions)
    RSSI and RTWP
    What is a CE (Channel Element) in WCDMA?
    Layer 3 Messages and 3G Events
    LTE Signalling Troubleshooting and Optimization ebook
  3. #2
    Level 1 Users
    Join Date
    Oct 2015
    Posts
    7
    Post Thanks / Like
    Credits
    101
    Rep Power
    0
    1. Run the SHOW N7OFC command in accordance with "Office ID" in alarm detailed information to check whether "Direct Route ID", "1st Round Route ID", "2nd Round Route ID", and "3rd Round Route ID" are configured.
    Yes -> Step 3.
    No -> Step 2.
    2. Run the ADD N7OFC command to add a static route, wait for three minutes, and then check whether the alarm is cleared.
    Yes -> End.
    No -> Step 3.
    3. Run the SHOW N7ROUTE command in accordance with "Direct Route ID" obtained in Step 1 to check whether the signaling route is configured.
    Yes -> Step 5.
    No -> Step 4.
    4. Run the ADD N7ROUTE command to add a signaling route in accordance with "Direct Route ID", wait for three minutes, and then check whether the alarm is cleared.
    Yes -> End.
    No -> Step 5.
    5. Run the SHOW N7ROUTE command to check whether the signaling links 1 to 16 have the following alarm:
    8400129 MTP3 link unavailable
    Yes -> Step 6.
    No -> Step 7.
    6. Handle the above alarm, and check whether the alarm is cleared.
    Yes -> End.
    No -> Step 7.
    7. Report Steps 3-6 in accordance with the "1st Round Route ID", "2nd Round Route ID", and "3rd Round Route ID" separately, and then check whether the alarm is cleared.
    Yes -> End.
    No -> Step 8.
    8. Run the SHOW ADJOFC command in accordance with "Office ID" in alarm detailed information to check whether the office is directly connected with the local office.
    Yes -> Step 10.
    No -> Step 9.
    9. Contact the peer maintenance personnel to transfer the signaling to the destination office, and then check whether the alarm is cleared.
    Yes -> End.
    No -> Step 10.


  4. Likes Haitham.Kotb liked this post
  5. #3
    Level 1 Users
    Join Date
    Mar 2017
    Posts
    4
    Post Thanks / Like
    Credits
    13
    Rep Power
    0
    do you have any info on ericsson small cell commands....ie Pico RBS 6402? Having some issues and not familiar at all with the command line for amos. it is very different from the macro nodes.


  6. Thanks anees_a thanked for this post

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •